Teledex DC Series Bedienungsanleitung PDF herunterladen

INCLUDED IN YOUR PACKAGE

Cordless Handset AC Adapter

Base Unit User Guide

NiMH Battery 10-foot, 4-wire RJ-11 Line Cord

Rubber Battery Screw Cover 15-foot, 8-wire RJ-45 Cable

Phillips Screw Clear Plastic Overlay

PREPARING TO USE THE DC9100 SERIES

1. Prepare to install the battery into the cordless handset by

firmly pressing down on the top of the battery cover and

sliding it off. If cover is secured with a screw, remove the

screw first.

2. Locate the lightly embossed numbers “1” and “2” on the

battery’s plastic connector.

3. Insert the battery connector into the handset’s connector

with the embossed numbers facing up.

Note: The handset may “beep” when the battery is connected. This is not

an indication that the telephone is ready to use. To obtain optimal perform-

ance of the telephone, be sure to charge the battery for 15 to 20 hours.

4. Replace the battery compartment cover and retaining screw.

5. Insert the provided rubber screw cover.

6. Turn the telephone base so the back panel is facing you.

Insert either end of the RJ-45 cable into the jack on the back

of the telephone labeled LINE.

7. Insert the other end of the cable into the jack on the AC

adapter labeled PHONE.

8. Insert one end of the RJ-11 line cord into the jack on the AC

adapter labeled LINE.

9. Insert the other end of this line cord into a telephone jack.

10. Plug the AC adapter into an unswitched

electrical outlet.

11.Once your telephone is connected, remove the plastic

overlay and place the paper faceplate over the keys. Replace

the plastic overlay by hooking the tabs on the overlay into

the recessed slots located on both sides. The overlay is

easiest to insert when the left or right side tabs are inserted

first, and the middle of the overlay is slightly bowed to allow

for insertion of the other tabs.

12.Place the cordless handset on the base unit.

CHARGING THE BATTERY

The rechargeable Nickel Metal Hydride (NiMH) battery must be

fully charged before using the phone for the first time. It is recom-

mended that that battery pack be charged for approximately 15

to 20 hours, without interruption, before use. To charge the battery,

place the handset, keypad down, in the base unit. Make sure the

CHARGE LED on the base lights. If the LED does not light:

1. Ensure that the AC adapter is plugged in.

2. Ensure that the AC adapter is not

plugged into a switched

electrical outlet.

3. Ensure that the handset charging contacts at the bottom of

the handset are making good contact with the base unit’s

charging contacts.

CLEANING THE BATTERY CONTACTS

To maintain a good charge, it is important to clean all charging

contacts on the handset and base unit. Use a pencil eraser or

other contact cleaner. Do not use any liquids or solvents

BATTERY SAFETY INSTRUCTIONS

1. Use only Teledex-approved battery replacements.

2. Dispose of used batteries according to local codes pertaining

to NiMH batteries.

3. Do not dispose of batteries in fire, as they may explode

4. Charge the telephone's batteries only while in the telephone

handset, and only by using the telephone base unit to charge.

Do not attempt to remove the batteries and charge them in

a separate charging unit.

5. Do not short-circuit the battery pack, as this may cause it to

explode or catch fire.

HANDSET/BASE REGISTRATION PROCEDURE

This procedure establishes an exclusive link between a specific

handset and base, thereby allowing no other access to this

specific base. To accomplish this procedure, place the handset

on the base in the charging position. The LINE indicator will

blink while the process is occuring. This process occurs each

time the handset is placed on the base in the charging cradle.

ADJUSTING THE RING VOLUME

The up and down volume keys will adjust the ringer volume of

the telephone. Additionally, the DC9100 series telephone has an

optional “courtesy” ring mode, wherein the ring volume begins

at the lowest setting, then automatically rings louder with each

successive ring during an incoming call. To select the courtesy

ring mode, follow these steps:

Press the FLASH key; then the 4 key; then the STORE key; then

the 1 key.

To return to regular ring mode: Press the FLASH key; then the 1

key; then the STORE key; then the 1 key.

ADJUSTING SPEAKERPHONE VOLUME

The speakerphone has eight (8) levels. To adjust speakerphone

volume, locate the volume up/down keys, located on the front

surface of the phone below the keypad. With the speaker active,

press the “down” arrow key to decrease the volume level, and

press the “up” arrow key to increase it.

RESTORE THE PRODUCT TO NORMAL OPERATION.

- IF THE PRODUCT HAS BEEN DROPPED OR THE CABINET HAS BEEN

DAMAGED.

- IF THE PRODUCT EXHIBIT A DISTINCT CHANGE IN PERFORMANCE.

10. AVOID USING A TELEPHONE (OTHER THAN A CORDLESS TYPE)

DURING AN ELECTRICAL STORM. THERE MAY BE A REMOTE RISK OF

ELECTRIC SHOCK FROM LIGHTNING.

11. DO NOT USE THE TELEPHONE TO REPORT A GAS LEAK IN THE

VICINITY OF THE LEAK.

PLEASE SAVE THESE INSTRUCTIONS

DC9100 SERIES DIAGRAM

DC9100 SERIES USERS GUIDE

900 MHz Single-Line Digital Cordless Guestroom Telephone

Telephone

(408) 363-3100

(800) 794-8353

Internet

www.teledex.com

store.teledex.com

[email protected]

Mailing Address

6311 San Ignacio Avenue

San Jose, CA 95119 USA

CONTACTING TELEDEX

RISKS. INCORRECT REASSEMBLY CAN CAUSE ELECTRIC SHOCK WHEN

THE APPLIANCE IS SUBSEQUENTLY USED.

9. UNPLUG THIS PRODUCT FROM THE WALL OUTLET AND REFER

SERVICING TO QUALIFIED SERVICE PERSONNEL UNDER THE FOLLOW-

ING CONDITIONS:

- WHEN THE POWER SUPPLY CORD OR PLUG IS DAMAGED OR FRAYED.

- IF LIQUID HAS BEEN SPILLED INTO THE PRODUCT.

- IF THE PRODUCT HAS BEEN EXPOSED TO RAIN OR WATER.

- IF THE PRODUCT DOES NOT OPERATE NORMALLY BY FOLLOWING

THE OPERATING INSTRUCTIONS. ADJUST ONLY THOSE CONTROLS THAT

ARE COVERED BY THE OPERATING INSTRUCTIONS, AS IMPROPER

ADJUSTMENT OF OTHER CONTROLS MAY RESULT IN DAMAGE, AND

MAY REQUIRE EXTENSIVE WORK BY A QUALIFIED TECHNICIAN TO

Telephone

1.800.451.4035

(North America)

+1.719.638.8821

Address

Cetis, Inc.

5025 Galley Road

Colorado Springs, CO 80915

Internet

www.teledex.com

[email protected]

1 2 3 4

Inhaltsverzeichnis

Seite 1 - DC9100 SERIES USERS GUIDE

INCLUDED IN YOUR PACKAGECordless Handset AC AdapterBase Unit User GuideNiMH Battery 10-foot, 4-wire RJ-11 Line CordRubber Battery Screw Cover 15-foot,

Seite 2

ADJUSTING HANDSET RECEIVE VOLUMEThe handset has four (4) volume levels. To adjust the handsetvolume, locate the volume up/down keys, located on thehan

Seite 3 - DC9200 SERIES USERS GUIDE

INCLUDED IN YOUR PACKAGECordless Handset AC AdapterBase Unit User GuideNiMH Battery 10-foot, 4-wire RJ-11 Line CordRubber Battery Screw Cover 15-foot,

Seite 4

press the “down” arrow key to decrease the volume level, andpress the “up” arrow key to increase it.ADJUSTING HANDSET RECEIVE VOLUMEThe handset has fo

Kommentare zu diesen Handbüchern

Keine Kommentare

Teledex DC Series Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Telefone Teledex DC Series herunter. Teledex DC Series User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Telefone Teledex DC Series